I for one always liked the idea of being strong enough to throw around some heavy weight in the gym. I feel if the weight is there, we might as well use it.
I remember when I first started training… all I could ever think of when I went into the gym – as I searched over at the older guys in the gym benching – was if I would be able to lift that one day; the weight Im referring to was a mere 45 lb bar and a 45 lb plate, either side. I viewed on in envy as I proceeded to max out on my bench with the barbells from the curling rack!!! (I was 12 years old)
So such as good athlete I set out a plan to increase my strength week via week. Back then my plan was simply to bench away with a particular weight until I achieved a certain number of reps without it being a strain before I moved onto the next weight and repeated the cycle.
This process had some (well actually just a little) thought behind it and was effective but very slow to yield results. However, even though it was only slightly effective in aiding the increase in strength it was actually very effective in creating a shoulder injury due to the repetitive nature of my workout. Im sure everyone has heard the term repetitive strain injury.
The training program I created led to a gigantic increase, not only in my bench press but my strength overall. My bench increased so greatly (40% to be precise) that it lead to me winning a Gold medal at the 2006 World Powerlifting Championships. So if you read on you will see how you too can increase your overall strength and more importantly HOW MUCH YOU BENCH!!!!!
|The Training Program Led To A
Huge Increase In My Strength Overall.
All these movements are intrinsically involved in the actions of the bench press. If we take a moment to think of this and look at the bench press from an analytical perspective – we start the movement with the shoulder joint in the flexed position and also in the adducted position – as we move through the eccentric phase of the exercise we transfer from those positions into the extended and abducted position.
Bear in mind that the muscles responsible for these actions are small in comparison to the prime movers of the bench press (pectorals major) and even the assisting muscles, triceps and anterior deltoid.
Exercising these rotator cuff muscles will aid in the stabilization of the shoulder joint as a whole, minimizing the risk of injury while also allowing you to control more weight during the performance of the exercise.
Lateral Raise Grip Variations.
Close-grip bench pressing increases the range of motion of the elbow joint during the “lock out” phase maximizing the number of motor units being utilized to complete the movement, in other words, transferring the emphasis from the pectoral muscles to the triceps. The increased strength gained from performing this exercise transfers perfectly into the traditional bench press because of the biomechanical similarities between the two movements.
Here a heavier weight will be used than when performing the regular exercise. As you lower the bar without aid and under complete control, your training partner should be ready to take up to 75% of the load when going through the concentric or positive phase of the movement, this process helps the muscles to adapt to the increased load in a more progressive manner, as well as the strength increase transfers to the conventional bench press in a relatively short time of time.
Thanks to muscle memory the body realizes that it has already adapted to using such weight, when performing the eccentric or negative phase the muscles brace in anticipation of the load and as they extend they make an elastic such as effect, the tension created allows one to press the increased weight under a greater level of control, in other words YOU HAVE GOTTEN STRONGER!!!!
Eccentric Flat Bench Press:
However my adapted process is not as intensive repetition wise, rep ranges are kept between six to eight and sets are performed completing the lower segment of the repetition only, thats from the sternum to the midpoint of the movement.
When performing the upper segment of the movement a block should be used, some such as to use a couple of phone books taped together. The bar is lowered from the lock out position to the top of the block and then pressed, this is a complete repetition.